How To Choose Suitable Breaking Hammer Drill Rods For Different Working Environments
For different work environments, the crushing hammer drill rod selected by users should also be different in order to achieve better work results. Do you know how to choose a suitable breaking hammer drill rod for different work environments? What are the issues to pay attention to when choosing a crushing hammer drill rod? The following text will provide the answer:
In the process of selecting drill rods, if they are straight headed, they are suitable for digging trenches or excavating soft layered rocks, as well as for neutral layered rocks. If it is a cross head steel drill, it is more suitable for some fine-grained concrete or some neutral concrete, as well as for crushing soft non layered rocks. If it is a flat headed steel drill, it is suitable for crushing medium hardness stones, or for crushing small stones that have already had some cracks, which can make their volume smaller.
How to choose suitable breaking hammer drill rods for different working environments
During this process, it should be noted that the drill rod cannot damage harder stones or soil. Therefore, in the future, when selecting and using, it is important to avoid using harder stones to prevent damage to the tool. If the steel chisel needs to be replaced, the steel chisel pin should be removed first, and then reinstalled. During this installation process, the steel chisel should be straightened first, and then the steel chisel pin should be inserted into it. However, if the steel chisel is reinstalled, the order should be opposite to that of disassembly, because at this time, the wear and tear of each component should be checked first. If there is any deformation at this time, it should be immediately polished and repaired, rather than ignored. During this process, lubricating oil coating can be applied to the active parts of the steel drill and the steel drill head before installing the steel drill.
If the steel drill has severe deformation, it may be very difficult to replace it. Therefore, when working for 100 to 150 hours, the work should be stopped and its quality should be carefully inspected. However, the prerequisite for all of this should be the purchase of a relatively good quality drill rod. Otherwise, not to mention a hundred hours of use, some inferior products cannot be guaranteed even after ten hours of use.
